Proline SMART16 Manual De Instrucciones página 7

1.Removing the presser foot
Turn the hand wheel anticlockwise to raise the
needle to its highest position. Raise the presser
foot lifter, and press the presser foot locking lever.
The presser foot will drop off automatically from
the locking device.
Type
Catcher presser
NOTE: Please select the applicable presser foot when sewing fabric. Do not use any presser foot other than
the above types.
REPLACING THE BOTTOM BOBBIN
Caution:
Always switch off and disconnect the appliance from the power supply and remove the foot pedal
replacing bottom bobbin.
Please use metal bobbins, otherwise the magnetic holder cannot tense the bobbin thread and work
properly.
1.Slide the bobbin 2.Put a new bobbin
cover switch to
the right and
remove the
bobbin cover.
SEWING
1. Turn the hand wheel anticlockwise to raise the needle to its highest position.
2. Raise the presser foot lifter and place the fabric you want to sew under the presser foot.
3. Lower the presser foot.
4. Rotate the pattern selection dial to select the stitch pattern you want.
Picture
Pattern 1 to 16
3.Hold the end of the upper thread
in the holder, with with one hand, and turn the hand
the thread going wheel anticlockwise with the
clockwise. Leave other hand, the needle thread
10cm of thread will pick up the bobbin thread
hanging out. and pull it up through the hole
under the needle.
2.Installing the presser foot
Put the presser foot under the presser foot locking
device, lower the presser foot lifter, press the
presser foot locking device to reset the foot, and
lift the presser foot lifter.
Usage
Sewing catcher stitches professionally,
along the fabric cutting edge to stitch and
sew the edges. Presser foot with guide
plate is used to align the selvage and
selvage maintain smooth.
EN - 5
Function
when
4.Replace the bobbin
cover and separate the
two threads and pull
them to the back of the
machine under the
presser foot, leaving
about 15cm hanging
there.