Adjusting The Self-Propel Drive; Preparing The Battery Pack For Recycling - Toro Power System 21852 Manual Del Usuario

Adjusting the Self-Propel
Drive
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive cable.
1. Loosen the cable-support nut
Figure 23
1. 25 to 38 mm (1 to 1-1/2
inches)
2. Self-propel-drive bar
3. Cable jacket
2. Hold the self-propel-drive bar 25 to 38 mm (1 to
1-1/2 inches) from the handle
3. Pull down the cable jacket (toward the machine)
until there is no slack in the cable
4. Tighten the nut on the cable support.
5. Release the self-propel-drive bar and ensure
that the cable is loose.
Note:
The cable must be loose with the
self-propel drive bar in the released position;
otherwise, the machine may creep when you
disengage the bar.
(Figure 23).
g009692
4. Cable-support nut
5. Cable support
(Figure 23).
(Figure 23).
Preparing the Battery Pack
for Recycling
Important:
Upon removal, cover the terminals of
the battery pack with heavy-duty adhesive tape.
Do not attempt to destroy or disassemble the
battery pack or remove any of its components.
Contact your local municipality or your authorized Toro
distributor for more information on how to responsibly
recycle the battery.
20