Kohler TOUCHLESS K-13670 Instrucciones De Instalación página 5

Fig. #6 and Fig. #7. Determine mounting location for
control unit. Location of the control unit will be limited
by the length of the supply hose and the faucet lead
wire. Note how supply hose and electrical tubing will be
routed.
Install mounting feet to control unit with screws
provided. Mount control unit to wall with appropriate
screws and anchors (as required). Four (4) drywall
screws are provided for mounting control unit.
Install seal washers in each end of supply hose and
connect supply hose to faucet shank and control unit
outlet.
Fig. #8. Install straight connector on control unit as
shown.
Determine length of electrical tubing required to run
between faucet and straight connector on control unit
and cut electrical tubing to length (as required).
Push faucet lead wire through electrical tubing. Push
electrical tubing end into straight connector on control
unit and tighten straight connector.
Connect faucet lead wire to circuit board. Electrical
tubing may be tied to faucet supply hose with cable ties
provided.
Kohler Co., Kohler, WI U.S.A.
Faucet
Shank
Supply Hose
Control
Unit Outlet
Mounting Foot
SINGLE SUPPLY
DOUBLE SUPPLY
Faucet Lead
Connection
Circuit
Board
Fig. #8
5
Faucet
Lead Wire
Supply
Electrical
Tubing
Control Unit
Fig. #6
Thermostatic
Mixing Valve
Supply
Fig. #7
Straight Connector
Electrical
Tubing
1007012-2-
B