Battery Instructions; Mounting Bracket - Cedar Ridge MTF4TPU Manual Del Usuario

INSTALLING THERMOSTAT SENSING BULB (OPTIONAL)
1. Pull out the sensing bulb from the two clips
located in the shipping position. There is
no need to take out the two bulb clips.
2. Take out the bulb clip from the hardware
package and insert it into the square hole.
Then insert the sensing bulb into the bulb
clip (see Figure 5).
CAUTION: Do not mix old and
new batteries. Do not mix alka-
line, standard (carbon - zinc), or
rechargeable (nickel - cadmium)
batteries. Do not dispose of
batteries in fire, batteries may
explode or leak.
• Batteries are included.
• Remove batteries when depleted.
• Be sure to observe proper polarity (+/-)
when installing or replacing the batteries.
Damage due to improper battery installation
may void the warranty on the product.
• For long periods of non-operation, remove
batteries from all components for safety.

Mounting Bracket

The mounting bracket is located on back panel
of heater (see Figure 7). It has been taped
there for shipping. Remove mounting bracket
from back panel.
Mounting
Bracket
Figure 7 - Mounting Bracket Location
12
All manuals and user guides at all-guides.com
INSTALLATION

BATTERY INSTRUCTIONS

Unscrew ignitor cap and install a AAA battery
with the + pointing out. Replace cap.
FASTENING HEATER TO WALL
Use only the last hole on each end of mounting
bracket to attach bracket to wall. Attach mount-
ing bracket to a wall only in one of two ways:
1. Attaching to wall stud: This method pro-
2. Attaching to wall anchor: This method
Decide which method better suits your needs.
Either method will provide a secure hold for
the mounting bracket.
www.usaprocom.com
Thermostat
Sensing
Bulb
Bulb Clip
N G
N G
Figure 5 - Moving Thermostat Sensing
Bulb
AAA
Battery
Positive
UP
Figure 6 - Installing Battery in Ignitor
Methods For Attaching Mounting
Bracket To Wall
vides the strongest hold. Insert mounting
screws through mounting bracket and into
wall studs.
allows you to attach mounting bracket to
hollow walls (wall areas between studs)
or to solid walls (concrete or masonry).
200032-01A