Cedar Ridge MTF4TPU Manual Del Usuario página 14

Placing Heater On Mounting
Bracket
1. Locate two horizontal slots on back panel
of heater (see Figure 11).
2. Place heater onto mounting bracket. Slide
horizontal slots onto stand-out tabs on
mounting bracket.
1. Snap the left and right foot columns to-
gether (see Figure 12).
2. Place the column assembly in the center
of the base cut out. Fasten column as-
sembly by using two Phillips head self
taping screws (provided) (see Figure 12).
3. Place leg bracket on the top of column as-
sembly and fasten it by using two Phillips
head self tapping screws (provided) (see
Figure 12).
4. Align four screw holes to the base of
the heater and attach it by using Phillips
head self tapping screws (provided) (see
Figure 13).
N G
Leg
Bracket
Foot
Columns
Figure 12 - Assembling Base Feet
14
All manuals and user guides at all-guides.com
INSTALLATION
INSTALLING BASE FEET
N G
L P
L P
N G
N G
Finished
Assembly
L P
L P
Base Cut Out
www.usaprocom.com
Horizontal
Slots
Figure 11 - Mounting Heater Onto
Mounting Bracket
5. Position the heater to the desired location.
Secure the base feet to the floor by us-
ing two Phillips head self tapping screws
(provided) (see Figure 14).
Figure 13 - Attaching Base Feet to Heater
Screw
Figure 14 - Securing Heater to Floor
Stand-Out
Tab
Mounting Bracket
(attached to wall)
Screw
Hole
Screw
200032-01A