Electrical Connection - Cedar Ridge MTF4TPU Manual Del Usuario

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Heating Coil Switch

When the switch is on I, the blower and heat-

ing coil turn on at the same time. It makes the

room temperature rises rapidly.

Blower Switch

When the blower and heating coil switch is

on O, turn the blower switch to I then the

blower turns on.

A 15 amp, 120 Volt, 60 Hz circuit with a prop-

erly grounded outlet is required. Preferably,

the heater will be on a dedicated circuit as

other appliances on the same circuit may

cause the circuit breaker to trip or the fuse to

blow when the heater is in operation. Plan the

installation to avoid the use of an extension

cord. Extension cords are for temporary use

only. If an extension cord must be used, it must

be UL/CSA certified, rated at 15A (1900W),

125V maximum with 14 AWG minimum and

constructed of two current carrying conductors

with ground. A heavy duty extension cord with

the shortest length possible for the connec-

tion is recommended and must not be longer

than 50 ft. (15.2 m). Do not coil or cover the

extension cord.

Electrical outlet wiring must

comply with local building codes

and other applicable regulations

to reduce the risk of fire, electri-

cal shock and injury to persons.

Do not use this heater if any

part of it has been under water.

Immediately call a qualified ser-

vice technician to inspect the

fireplace and replace any part

of the electrical system which

has been under water.

200032-01A

All manuals and user guides at all-guides.com

OPERATION

SWITCHES OPERATION