Replacing The Uvc Lamp - Oase FiltoClear 5000 Instrucciones De Uso

Installing the UVC unit head

Replacing the UVC lamp

The UVC lamp is a wear part. Replace the UVC lamp once the indicated number of operating
hours has been reached. This ensures optimum filtering performance.
FiltoClear
5000
13000
19000
31000
Prerequisite:
 The UVC unit head has been removed. (→ Removing the UVC unit head)
 Only use UVC lamps, the identification and power data of which correspond to the information
on the type plate. (→ Technical data)
How to proceed:
 Removal: Turn the bayonet ring all the way to the "lock open" position to remove the holding
plate and the UVC lamp.
 Installation: Turn the bayonet ring all the way to the "lock closed" position. Otherwise you
cannot install the UVC unit head.
– On delivery, the bulb of the UVC lamp is protected by a transport guard. The lamp guard is
not required for the lamp function and does not need to be reinstalled.

If necessary remove a lamp guard stuck in the quartz glass as follows:
 Remove the quartz glass. (→ Cleaning/replacing the quartz glass)
 Carefully and steadily knock the rotor lid with the quartz glass against a firm surface. The
lamp guard will slowly slide out of the quartz glass.

OSRAM UVC lamps can only be installed without the holding plate. OASE therefore recom-
mends using Philips UVC lamps.
48
UVC lamp power
18 W
24 W
42 W (optionally 36 W)
60 W (optionally 55 W)
Replace UVC lamp after
8000 h (one pond season)
42 W / 60 W: 12000 h
36 W / 55 W: 8000 h
FCL0017