Kraftixx KX-ARM 3637 Li Kit Manual De Instrucciones Original página 22

indicator on the charger.
The battery pack can become a little warm during
the charging. This is normal.
If the battery pack fails to charge, check:
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging
contacts
If the battery pack still fails to charge, send
•
the charging unit
•
and the battery pack
to our customer service center.
To ensure that items are properly packaged
and delivered when you send them to us,
please contact our customer service or the
point of sale at which the equipment was
purchased.
When shipping or disposing of batteries and
cordless tools, always ensure that they are
packed individually in plastic bags to prevent
short circuits and fi res.
To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
Installing the battery pack (Fig. 7)
Open the battery cover. To do so, fl ip up the cover
as shown in Fig. 7. Then insert the batteries in the
mounts as shown in Fig. 7.
Important!
Use only batteries which are charged to the same
level. Never combine full and half-full batteries.
Always charge the two batteries simultaneously.
The device's operating time depends on the bat-
tery with the lower charge level. The two batteries
must always be fully charged before use. Close
the battery cover by swinging it down, and make
sure that it latches in place correctly.
Battery capacity indicator (Fig. 12)
Press the button for the battery capacity indicator
(Item A). The battery capacity indicator (Item B)
shows the charge status of the battery using 3
LEDs.
Anl_KX-ARM_3637_Li_SPK13.indb 22 Anl_KX-ARM_3637_Li_SPK13.indb 22
GB
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
Fill level indicator of the grass catch bag
(Fig. 8)
The grass catch bag is equipped with a fi ll level
indicator (A) which is opened by the airfl ow that
the lawn mower generates during operation. If the
fl ap closes during mowing, the grass bag is full
and must be emptied. To ensure the proper func-
tioning of the fi ll level indicator, the holes under
the fl ap must always be kept clean and passable.
Using the mulching adapter (Fig. 9)
In mulching mode the cuttings are shredded in
the enclosed mower housing and then spread
back onto the lawn. It is not necessary to gather
and dispose of the grass.
Important! Mulching is only possible if the lawn
is relatively short.
Warning!
Insert the mulching blade only when the motor
has been switched off and the safety plug has
been pulled out.
To use the mulching function, disconnect the
grass catch bag, slide the mulching adapter (Fig.
9/Item 15) through the ejector opening and close
the ejector fl ap again.
- 22 -
26.05.2021 13:46:27 26.05.2021 13:46:27