Wall Mounting; Attaching The Mounting Plate; Attaching The Charging Cable To The Wall Bracket; Connecting The Accessories Holder (If Required) - Miele HS19 Instrucciones De Funcionamiento

You will need a suitable location near
a free electrical outlet for mounting the
appliance on the wall.
Wall mounting (Figs. 14 + 15)
The supplied wall bracket has a mount-
ing plate with a bag of screws attached
to the back.
Attach the mounting plate to the point
on the wall where you want the wall
mounting to be.
 Remove the bag of screws.
 Press the release catch at the bottom
of the wall bracket.
 Remove the mounting plate from the
wall bracket by sliding it downwards.

Attaching the mounting plate

(Figs. 16 + 17)
2 plugs and 2 T20 TORX screws are
supplied for attaching the mounting
plate to the wall.
You will also need an electric screw-
driver or a drill (with a 1/4" drill bit).
Depending on how your vacuum
cleaner is configured, select a distance
of 17 3/4" or 38 1/2" (45 cm or 98 cm)
between the bottom edge of the mount-
ing plate and the floor.
Be careful not to damage any electri-
cal in the wall.
 Attach the mounting plate to the wall.
Attaching the charging cable to the
wall bracket (Figs. 18, 19 + 20)
A cable compartment is located on the
underside of the wall bracket.
 Press both release catches on the un-
derside of the wall bracket and re-
move the cable compartment cover.
 Plug the supplied charging cable into
the opening from above.
 Lay the charging cable in its guide.
 Refit the cover and close the cable
compartment.
Connecting the accessories holder
(if required) (Fig. 21)
An accessories holder is supplied for
storing the three-piece accessory set
(see "Using the accessories supplied").
 Push the accessories holder on to the
wall bracket as far as it will go.

Connecting the wall bracket

(Figs. 22 + 23)
 Slide the wall bracket down into the
mounting plate from above until it au-
dibly clicks into place.
 Slide the PowerUnit of the fully as-
sembled vacuum cleaner, with the
battery inserted, down into the wall
bracket from above.
 Plug the charger into the power
socket.
The charging process will start.
Battery charging state indicator
(while charging) (Fig. 24)
The battery charging state is displayed
on the PowerUnit.
en-US
19