Motorola Solutions MTP6000 Guia De Instalacion página 11

Avoid visual or physical obstruction, route the antenna cable
down inside the door moulding and beneath the carpets and
seat(s). Allow sufficient slack at the connector end of the
cable to reach the For Mobile Equipment (FME) connector of
the cradle.
Position the antenna in such a way to maintain a separation
distance of at least 8 inches (20 cm) between the antenna
connected to the Car Kit and the body of any user, or nearby
person, to ensure compliance with regulations on radio
frequency (RF) exposure.
Note: Antennas with a gain exceeding 6 db do not comply
with European Telecommunications Standards
Institute (ETSI) RF exposures and are not allowed to
be used with this product.
Rooftop Combined Global Positioning System
(GPS)/TETRA Antenna Kit
To install a combined GPS/TETRA antenna kit, refer to the
installation manual provided in the antenna kit and to the
explanations below.
Kit Components
See Figure 4.
1. Combined GPS/TETRA typical antenna
2. 5 m RG58 FME to unterminated loose FME cable,
supplied in kit
3. 5 m RG174 MFME to FME cable
4. Duplexer
5. 2.4 m DC Adapter Cable (FTN6790)
6. 1 m FME cable
Installation procedures
Install the kit components in the following suggested order:
9