Operating Specifications; Safety And General Information - Motorola Solutions MTP6000 Guia De Instalacion

7. To avoid possible interference with blasting operations,
turn your radio OFF before entering an area where you
may be close to electrical blasting caps, in a "blasting
area" or in areas posted as "Turn OFF two-way radios".
Obey all signs and instructions.

Operating Specifications

MTP6000 Car Kit Junction Box (PMLN6662)
Input voltage range: 10.8 DC to 16.6 VDC

Safety And General Information

A properly installed Car Kit minimizes service calls. When
mounting the components of the Car Kit, consider the
following factors:
• The mounting surface must have sufficient strength to
support the item being mounted to prevent it from
becoming loose over time.
• Do not attach components to any part of the vehicle that
is subject to excessive vibration.
• The proposed location of the item being mounted or
wires/cables attached must not interfere with driver/
passenger seating or leg space.
• Use the supplied mounting hardware.
• Ensure that the cables are not stretched, and not subject
to heat from the engine, transmission housing or heating
ducts.
• Crimp or tie together all the wires using a cable tie to
keep tidy.
• Ensure that screws are securely fastened on all
connectors.
• Do not run cables over sharp edges that may cause
excessive wear or chaffing of the cable insulation.
• Do not install components in locations where they may
cause interference to the operation of the vehicle's
controls.
5