Carrier 40VD005L-7E-QEE Manual De Instalación Y Propietario página 18

Installation Procedures
Cutting and Enlarging
Cutting or enlarging pipes should be carried
out by installation personnel according to
the operating criterion, if the tube is too
long or the flare opening is broken.
Connecting
1. Connecting circular terminals:
The connecting method of the circular terminal is
shown in the Fig. Remove the screw, connect it to
the terminal tier after inserting it through the ring
at the end of the lead and then tighten it.
2. Connecting straight terminals:
The connection method for circular terminals
is shown in the Fig. Loosen the screw before
inserting the line terminal into the terminal tier,
tighten the screw and confirm that it has been
clamped by pulling the line gently.
3. Pressing connecting line:
After line connection is completed, press the
connecting line with clips that should be pressed
on the protective sleeve of the connecting line.
terminal tier
correct
pressing
pressing clip
11
Connecting
circular terminals:
wrong
pressing