1f. Using a T15 torx remove screws in the wheel well liner, pull the liner away from the
fascia.
1h. Starting from the wheel well area, carefully pull the fascia away from the vehicle (be
careful not to pull it too far away from the vehicle to avoid damage) using plastic fascia
removal tools to help release the clips along the way, work your way toward the middle
from each wheel well.
©2018 Horizon Global Americas Inc. - Printed in Mexico
1g. Remove the hitch access panel in the middle of the fascia, using a T15 torx remove
screws that hold the bottom of the fascia to the vehicle.
*CAUTION* Be extra careful at the taillight area, the fascia attachment is tight below
the taillight and the bottom of the taillight is very sharp and will cause scratches to
fascia if you're not careful. Masking the bottom of the taillight is recommended. There
are two clips to be released below the taillight See Fig. 2. Unplug the electrical
connectors from behind the fascia. Set fascia aside for reinstallation.
Sheet 5 of 21
76266NP
10-10-18
Rev. A