Kit Assembly - Metra 99-7340B Instrucciones De Instalación

DIN radio provision with pocket
1. Remove the metal "DIN" sleeve and trim
ring from the aftermarket radio.
2. Slide the sleeve into the top opening of
the radio housing and secure by bending
the metal locking tabs down. (Figure A)
3. Snap the pocket into the bottom
opening of the radio housing. (Figure B)
4. Slide the radio into the sleeve until it
clicks in. (Figure B)
5. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
6. Secure the radio assembly to the
dash using the factory screws, then
reassemble the dash in reverse order of
disassembly to complete the installation.

KIT ASSEMBLY

(Figure A)
(Figure B)
ISO DIN radio provision with pocket
1. Remove the metal "DIN" sleeve and trim
ring from the aftermarket radio.
2. Secure the ISO brackets to the radio
using the screws supplied with the
radio. (Figure A)
3. Snap the pocket into the bottom
opening of the radio housing. (Figure B)
4. Slide the radio into the top opening
of the radio housing until it clicks in.
(Figure B)
5. Attach the ISO trim ring to the
completed radio assembly. (Figure B)
6. Locate the factory wiring harness and
antenna connector in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
7. Secure the radio assembly to the
dash using the factory screws, then
reassemble the dash in reverse order of
disassembly to complete the installation.
(Figure A)
(Figure B)
REV. 5/21/2018 INST99-7340B
3