Instrucciones Generales Relativas A Seguridad Del Usuario - Hayward HCP5000 Manual De Instrucciones

2006/42 / EC; Low Voltage Directive 2006/95 / EC, UNE EN 60204 1: 2007; European
EMC Directive 2004/108 / EC; Machine safety standards UNE-EN-292.1, UNE-EN-292.2;
Standard PR EN 809 and EN EN¬60.355-2-41 .; High efficiency EC Regulation 640/2009.

INSTRUCCIONES GENERALES RELATIVAS A SEGURIDAD DEL USUARIO

The enclosed safety recommendations are based on our experience and on normal use of
the equipment.
The Equipment security can only be guaranteed if their use corresponds to what is
indicated in the information and diagrams supplied by the manufacturer. It is mandatory to
meet what is legislated by the Safety Standards in force in each country.
Be sure equipment is properly selected the application for which it was intended and that
their status, installation, commissioning and subsequent use are correct .
Before starting up the pump, all its elements, especially those relating to security, must be
properly installed and secured. Never operate the pump with non authorised people in the
area.
All installation, repair and maintenance should always be with the team switched off
the mains
While the machine is in operation it cannot be moved or its position corrected. These
operations should always be done with standstill equipment.
Never use the cord or the discharge pipe as a means to raise or support the pump.
You must place a rope, wire rope or chain, appropriate to the weight attached to the handle
or hook intended for it.
Close checks the condition of the installation. If your state is not safe, the equipment must
be stopped and proceed to repair. The necessary spare parts will be the original
manufacturer or recommended by him. The use of other spare parts from another source,
or original spare parts rectified by third parties is not allowed and exempt the manufacturer
or supplier of all its responsibilities.
TRANSPORTE
The manufacturer supplies the equipment protected with proper packaging, so that when
transporting or storing will not be damaged preventing proper installation and / or
operation.
The user, upon receipt of the equipment, shall check the state of the external packaging. If
signs of major damage this must be stated formally to whom it delivers. Also shall check
the state of content; if the defect presumably would prevent proper operation, it shall be
submited, also formally, to the provider within 8 days from receipt.
When stored humid environments should be avoided. Due to temperature changes
condensation may occur, also, in order to avoid dilatation misalignments, avoid the sun
exposure.
17