Hayward HCP5000 Manual De Instrucciones página 26

Before starting the installation process, you should read this operation
manual carefully. Installation must be in accordance with local regulations.
DESCRIPTION
The prefilter element is the equipment that performs filtering of the suspended solids. Placed on the suction of the
recirculation pumps, prevents impellers being blocked. Our pre-filters are designed to work preferably in private
and public pools, with clean waters lightly treated.
RESPONSIBILITY
All equipment supplied is adequately protected to avoid accidents, but in any case all safety recommendations on
the equipment, joined documents and especially local regulations that apply must be followed.
It is the sole responsibility of the installer / user the particular risks that could exist in each facility and not to allow
the connection of any equipment without adequate protections.
GENERAL INSTRUCTIONS FOR USERS SAFETY
The above safety recommendations are based on our experience and on a normal use of the equipment.
The safety of the equipments supplied can only be guaranteed if their use corresponds to the one indicated. It is
mandatory to follow the Safety Standards in force in each country.
Be sure that the equipments had been correctly selected according to the application for which it was intended
and that their status, installation, start up and subsequent use are correct.
All installation, repair and maintenance should always be with done with the equipment switched off the
mains
While the equipment is in operation cannot be moved or it position being corrected. These operations should
always be at a standstill.
Close check the condition of the installation. If its status seem not safe, the equipment must be stopped and
proceed to repair. The necessary spare parts will always be original from the manufacturer or the ones
recommended by him. The use of other spare parts from any other source, or original spare parts modified by
third parties is not permitted and exempt the manufacturer or supplier of all their responsibilities.
TRANSPORT
The manufacturer supplies the equipment protected with the proper packaging, so that when being stored or
transported will not suffer any damage that prevent for a proper installation and / or operation.
The user, upon receipt of the equipment, will check the state of the outer packaging. If there are evidence or signs
of major damage this must be stated formally to whom is delivering it. Also check the state of content; whether
there is any damage that probably would prevent proper operation, it shall, also formally, be said to the provider
within 8 days from receipt.
INSTALLATION AND SETUP
5.1 Location
Access to the equipment must be restricted so that anyone cannot access it un intentionally. Security elements
that prevent children access and others non authorised people should be installed. Unauthorised people and
specially children they should never stay in the place while installation works.
26