Hayward HCP5000 Manual De Instrucciones página 27

It is important to plan enough space for the pre-filter basket easily being removed vertically.
It is recommended to insert elastic sleeves which absorb the pump vibration and the expansions of the installation
pipes due to dilatation on the suction side of the prefilter.
MAINTENANCE / STORAGE
If the prefilter is attached to a pump or other equipment connected to the power supply, be sure to disconnect it
from the mains before any manipulation.
Periodically check and clean the pre-filter basket. This must be done with the pump stopped. To extract the
prefilter basket, place both the suction and discharge valves in its "closed" position. Release the pre-filter cover,
remove the basket and clean it under a tap. Avoid hitting the prefilter basket to prevent any damage.
To replace the basket, insert it gently into its original position. Place the gasket in the lid and greased with
Vaseline. Do not put any chemical products inside the basket.
If the pump is shut down for long periods of time, or if there is danger of frost, the prefilter should be emptied
through the drain plug. Before re-starting the pump, replace the plug with its seal and refill prefilter with water.
To apply for any spare parts, you should specify the name of the spare part and the position number according to
the exploded drawing and the data existing in the nameplate on the motor.
The technical data given below is approximate.
RECYCLING
WARRANTY
The supplier will replace or repair free of charge in any AGREED TECHNICAL SERVICES, for a period of 24
months from the date the product left our warehouse, any product that may show manufacturing defects. This
warranty will be reduced to 12 months for pumps continuous or permanent service.
In accordance with current legislation, the supplier is not liable for damages caused to our equipments due to
improper repair or if its parts have been replaced by non-original or manufacturer approved parts or pieces. The
supplier is not liable if repairs are not carried out by our Agreed Technical Services.
The supplier is considered exempt from any liability for any direct or indirect that may occur to the equipment
due to faulty installation, lack of maintenance, negligent use, manipulation by unauthorized personnel
The supplier is considered exempt from any liability due to electrical overload.
In any case, the supplier responsibility is limited to the replacement of the defective part in the shortest possible
time without being in any way liable for other responsibilities or compensation.
Disposal of old appliances. Based on the European standard 2002/96 / EC Waste Electrical
and Electronic Equipment (WEEE), old appliances can not be disposed of in the normal
unsorted municipal waste containers; must be collected separately to optimize the recovery
and recycling of materials they contain and reduce the impact on human health and the
environment. The symbol of the crossed out dustbin is marked on all products to remind
consumers the obligation to classify them for a separated collection. Consumers should
contact a local authority or retailer for information concerning the proper disposal of their
27
appliance.