DeWalt DWV012 Manual De Instrucciones página 6

English
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
These heavy-duty vacuums are for professional use.
DO nOT let children come into contact with the tool.
Supervision is required when inexperienced operators use
this tool.
nOTE: This vacuum is intended for commercial use.
ASSEMBLY AND ADJUSTMENTS (FIG. A, C–E)

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.

WARNING: When using electric appliances, always
follow basic safety precautions to reduce the risk of
fire, electric shock and personal injury.

WARNING: The filters 9 (Fig. C) must always be in
place while vacuuming, except as described under
Wet Pick Up Applications under Operation. When
vacuuming fine dust, you may also use an additional
paper bag or fleece bag to make emptying the
canister easier.
Fig. C
1. If optional paper or fleece bag
as shown in Figure D.
nOTE: Be careful not to tear the bag. Place bag securely
onto the backside of the inlet
for maximum dust collection performance.
2. Place the vacuum head 3 onto the canister and secure
it by closing the canister latches
3. Insert end of hose 7 into twist-lock hose inlet
rotate counterclockwise to lock in place.
Fig. D
10
Fig. E
7
4
All manuals and user guides at all-guides.com
OPERATION

To Operate the Vacuum (Fig. F)
1. Plug the power cord into an appropriate outlet.
2. Turn the on/off/tool control switch
3. Set the variable suction dial
4. Follow the direction under Connecting to Power
9
Connecting to Power Tools (Fig. A, G)
1. Plug the vacuum power cord into an appropriate outlet.
is to be used, install
18 2. Plug the power tool into the outlet
3. Turn on/off/tool control switch
to provide a tight seal
10
4 .
10 and
4. To switch back to manual mode, turn the on/off/tool
18
5. Choose the correct power tool adaptor
6. Attach the suction hose
10
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
position ( ).
to the desired position.
14
This feature allows the user to control the vacuum's
power, suction and noise.
nOTE: This setting also controls the level of suction. This
is very useful in applications where the vacuum creates
unacceptable levels of drag to the work piece.
Tools to connect to the power tool to be used.
Fig. F
14
15
position . This allows the vacuum to be turned on
and off automatically with the power tool.
nOTE: The vacuum cleaner starts automatically within
0.5 seconds and continues to run for 15 seconds after
the power tool has been turned off.
control switch to the ON position ( ). in manual
15
mode the tool and the vacuum are turned on and
off independent of each other.
power tool connection on the tool to be used, refer to
Accessories under Maintenance. Attach power tool
adaptor 20 to power tool.
to the power tool adaptor.
7
Fig. G
15 to the ON
15
.
13
to the ACTIVATION
to fit the
20
7
20