Filter Care - DeWalt DWV012 Manual De Instrucciones

Automatic Filter Cleaning System
This vacuum has a highly effective filter cleaning system
which minimizes filter clogging. Every 30 seconds, one of
the two filters gets automatically cleaned. The cleaning
process alternates between the filters and continues
through the life of the unit.
nOTE: It is normal to hear a clicking sound during
this process.
nOTE: After many hours of operation the automatic filter
cleaning system may not be effective. When this happens
the filters will need to be cleaned or replaced. Refer to Filter
under Maintenance.
Wet Pick Up Applications (Fig. A, H)

WARNING: DO NOT connect power tools to
outlet 13 when using the vacuum for wet pick up.

WARNING: Plug vacuum into GFCI protected outlet
when using the vacuum for wet pick up.
NOTICE: DO NOT remove ball float
cause damage to the vacuum. The ball float keeps
water from entering the motor.
Before using the vacuum for wet pick up:
• Ensure the canister is empty and free of
excessive dust.
• Remove filters 9 .
• Plug vacuum into a GFCI protected outlet.
Fig. H
To Empty Canister (Fig. A, H)
The ball float valve 22 will block air to the motor when the
canister is full and the sound of the motor will change at
once. When the motor has a high pitched sound and air/
water flow stops, empty the canister.
1. Turn off vacuum and unplug cord from outlet.
2. Unlatch canister latches and remove vacuum
4
head .
3
3. Empty contents of canister 6
or drain.
To Convert Back to Dry Vacuum
Operation (Fig. A)
1. Empty canister, refer to To Empty Canister instructions.
2. Place canister upside down position until dry. DO NOT
use wet canister for dry pick up.
3. Place vacuum head 3 on a level surface until dry.
4. Reinstall filters when vacuum head is dry. See Filters
under Maintenance.
All manuals and user guides at all-guides.com
5. When canister is dry place the vacuum head
Telescoping handle (Fig. A, I)
Press release button
handle
To Shut Down (Fig. A)
, doing so will
22
1. Turn on/off/tool control switch
2. Unplug the unit.
MAINTENANCE

Filter (Fig. A, J, K)

Filter Care

The HEPA filters included with this vacuum are long life
filters. To be effective in minimizing dust recirculation,
especially in lead paint (EPA RRP Rule) applications, the
filters MUST be installed correctly and in good condition.
22
To Remove Filters
1. Turn on/off/tool control switch
2. Release canister latches
3. Turn each filter
into a suitable container
canister and secure it by closing the canister latches
to raise and lower the telescoping
17
.
16
Fig. I
15
position ( ).
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
15
( ) and unplug cord from outlet.
4 and remove vacuum head
from canister. Place vacuum head on a level surface
upside down.
9 counterclockwise by gripping it
on the plastic end cover as shown, and carefully
remove from head, ensuring debris does not fall into
mounting hole.
nOTE: Use care to not damage filter material.
Fig. J
9
English
3 onto the
4 .
16
17
to the OFF
to the OFF position
3
5