Optional Accessories - DeWalt DWV012 Manual De Instrucciones

English
4. Inspect filters for wear, tears or other damage.
nOTE: If there is any doubt on the condition of the
filters they MUST be replaced. DO NOT continue use if
filters are damaged.

WARNING: Never use compressed air or a brush to
clean filters, otherwise damage to the filter membrane
will occur which will allow dust to pass through the
filter. If needed, rinse with room temperature water
and let air dry. Cleaning of the filters is typically
unnecessary. Even if the filter is covered with dust,
the automatic filter cleaning system will maintain
maximum performance and continue to function. If
visual damage to the filter membrane exists, replace
filters. Filters typically last between six and twelve
months, depending on use and care.
To Install Filters
1. Ensure filter seal 24 is in place and is secure
2. Line up filter threads 23 to vacuum head threads and
using moderate force, turn filter clockwise until tight.
nOTE: Use care to not damage filter material.
3. Place the vacuum head 3 onto the container and
secure it by closing the canister latches
Fig. K
24
Cleaning

WARNING: Using a damp cloth, clean dust from
air vents at least once a week. Wear proper ANSI
Z87.1 (CAN/CSA Z94.3) eye protection and proper
respiratory protection as required by OSHA or
other governmental/provincial institutions for the
application being performed.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Storage (Fig. L)
1. Empty the canister, refer to To Empty Canister
under Operation.
2. Clean the vacuum inside and outside.
3. Clean or replace filters, refer to Filters.
6
All manuals and user guides at all-guides.com
4. Store the suction hose and the power cord as shown in
the illustration. Place the unit in a dry room and secure it
from unauthorized use.
nOTE: Plug inlet plug
inside canister when suction hose is removed. You
can also attach the ends of the hose together and lock
together with the twist-lock end.
Accessories

4 .
23
Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact D
Tool Co., 701 East Joppa Road, Towson, MD 21286, call
1-800-4-D
www.dewalt.com.

Optional Accessories

19 into inlet 10
Fig. L
19
10
WARNING: Since accessories, other than those
offered by D WALT, have not been tested with this
e
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories should be used with
this product.
e
WALT (1-800-433-9258) or visit our website:
e
HEPA filter: Captures
99.97% of all particles
DWV9320 (some models)
greater than or equal to
0.3 microns. Required
DWV9330 (some models)
when picking up lead
paint debris.
5"–6" (127–152 mm)
DWE46100 Cutting/tuckpointing
shroud
D25301D Dust extraction adapter
5" (127 mm) Surfacing
DWE46152
shroud
DWH050 Universal drilling
DWH050K
dust extraction system
to keep debris
WALT
e
WALT Industrial