Tabla de contenido
Publicidad
Technical Information / Données techniques / Datos tecnicos
Recommended water
pressure
Max. water pressure
Recommended hot
water temp.
Max. hot water temp
Flow rate
*Please know and follow all applicable local plumbing codes when setting the temperature on the water heater.
* Vous devez connaître et respecter tous les codes de plomberie locaux applicables pour le réglage de la température du
chauffe-eau.
*Debe conocer y cumplir todos los códigos locales aplicables para ajustar la temperatura del calentador de agua.
Installation Considerations
• For best results, Hansgrohe recommends that
this unit be installed by a licensed, professional
plumber.
• Please read over these instructions thoroughly be-
fore beginning installation. Make sure that you
have all tools and supplies needed to complete
the installation.
• This trim is for use with iBox Universal Plus model
01850181 (not included).
• To prevent scald injury, the maximum output tem-
perature of the shower valve must be no higher
than 120°F. In Massachusetts, the maximum out-
put temperature can be no higher than 112° F.
• This mixing valve is for use with a showerhead
rated at 5.6 L/min (1.5 GPM) or higher.
• Adjust the rotational limit stop (see page 20)
during installation. Further adjustments may be
4
Pression d'eau recommandée
Pression d'eau maximum
Température recommandée
d'eau chaude
Température maximum d'eau
chaude
Capacité nominale
Presión recomendada en
servicio
Presión en servicio max.
Temperatura recomen-
dada del agua caliente
Temperatura del agua
caliente max.
Caudal máximo
necessary due to seasonal water temperature
changes.
• Do not install a shut-off device on either outlet of
this valve. Use of such a device can defeat the
ability of the valve to balance the hot and cold
water pressures.
• The pressure balance trim is suitable for a one-
function installation, such as a single showerhead
or handshower.
• The pressure balance trim may be used in a tub/
shower application using a diverter tub spout.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
5.5 GPM @ 44
PSI
Publicidad
Tabla de contenido
