HURAKAN HKN-ME709 Manual Del Usuario página 42

EN
4. Clean the area around brewing unit competely. And then,
install dreg drawer again.
5. Take out brewing original unit with handle. Slide into the initial
position. Be sure the brewing unit is well positioned after hearing
"clip", then install the dreg drawer. Close the brewing door finally.
NOTE: When put back the brewing unit, never push the flake
where there is a word"press", or it will cause damage to the
machine.
WARNING: If the brewing unit is not in the correct place,
display show BREWING UNIT MISSING, and machine can not work
properly.
6. Usually, the bean tank is not required to be clean. Clean it with cotton if needed.
7. Clean the milk-frothing device
Take off the metal tube, Spout can be taken off with the spanner
on the spoon. Clean the metal tube and nozzle with water. If the
nozzle was blocked, clean it with pin, wash it with water.
Re-assembly after cleaning.
WARNING: Make sure the machine is power off and the
steam/hot water pipe is cooling down completely
2.7.2 Cleaning the water tank filter
Remove the water tank. There is an inlet which connects with water tank. Turn the cover
anticlockwise, take out thefilter in it and clean the filter. Re-assembly after cleaning.
The water inlet is located
under the water tank
2.7.3 Storage
42
Water
infall
Clean the area
around brewing unit
Put back brewing unit
Clean metal tube and nozzle
to keep the spout expedite
Filter
Turn the cover anticlockwise
take off the filter and clean it
Don't press here
Nozzle
Milk-Frothing
Metal tube