Joovy Cocoon X2 56X Manual Del Usuario página 4

EN FR ES
• Before loading or unloading ensure that the wheel brakes are engaged.
• Ensure that both shoulder straps are attached to the waist strap buckles. See Figure 7.1.
• Unlatch the waist/shoulder buckle by squeezing the latch releases on both sides of the buckle and removing the male ends of each buckle.
See Figure 7.2.
• Carefully place the child in the seat with the shoulder straps over their shoulders and chest. Then place the crotch strap between the
child's legs.
• Bring the seat belt around the child's waist and insert the male ends of the waist/shoulder buckle into the female buckle. Ensure that they snap
into place. See Figure 7.3. Tighten the waist belt to be snug around the child's waist.
• Both the shoulder straps and the waist/crotch straps may be adjusted using the sliding buckles on these straps. See Figure 7.4.
8 Storage Compartment Loading/Unloading
• Before loading or unloading the Storage Compartment ensure that the wheel brakes are engaged.
• To access the storage compartment, unzip the access door on the rear of the stroller. See Figure 8.1.
9 Folding the Stroller
• Keep children away from stroller while folding.
• Engage the rear brakes and position the stroller with the handle bars closest to you.
• Open the access door on the rear of the stroller as shown in Figure 9.1.
• Locate the clamps on BOTH sides of the frame inside the rear compartment.
• Slide the button on the clamp towards you and pull the clamp off of the tube. Swing the clamp all the way towards the front of the stroller.
See Figures 9.2. Repeat this procedure on the other side.
• To fold, push the secondary lock on the right side down while pushing the upper tube on that side towards the front of the stroller.
See Figure 9.3. Push the handle bar downward until the stroller is collapsed. See Figure 9.4.
• Use caution not to catch the clamps or the secondary lock against the rear of the seatback when folding.
CAUTION: While folding the stroller, be careful to keep your fingers from being pinched by moving parts.
Assembling and Using the Fixed Front Wheel Attachment
To ensure safe operation of your jogging stroller, please follow these instructions carefully.
10 Unpacking the Product
• Carefully remove the fixed front wheel/attachment tube assembly and documents (not shown) from the box and plastic bag.
See Figure 10.1.
• Remove any packing materials from the product.
• Discard all packaging materials properly. Do not allow children to play with them.
11 Installing the Fixed Front Wheel
• Tilt the stroller so it is resting on the handle bar and the rear wheels.
• Remove one of the front swivel wheels by opening the quick release lever and pulling the front wheel post from the housing. Repeat this
process to remove the other front wheel. Return the quick release levers to their closed positions.
• Remove the locking pin with clamp from the attachment tube (located on the lower front end of the stroller) by opening the clamp and
unscrewing the nut.
• Insert the front wheel tube into the housing at the center front of the stroller, with the wheel pointing forward. Line up the holes on the sides.
Insert the locking pin through the holes, reattach and tighten the locking nut, then rotate the quick release lever to the closed position to secure
in place. See Figure 11.1.
• Pull the wheel away from the stroller to ensure it is securely installed.
All manuals and user guides at all-guides.com
WARNING
!
Avoid serious injury from falling or sliding out.
Always use the restraint system.
WARNING
!
ALWAYS keep children away from the stroller when folding.
Jogging Stroller Mode
CAUTION
!
Adult assembly is required for this product. No tools required.
WARNING
!
Use caution not to get pinched by the locking clamp.