Checking Work; Control Elements - Prebena PKT Fillmaster 400 Manual De Instrucciones Original

MIND OUT!
Defective pressure and cooling lines can break and a current of the compressed air can cause
property damage.
 Before connecting check, if the compressor, pressure and cooling lines have defects.

Checking Work

To make certain of irreproachable work of the compressor before the first start do as follows:
 Use the compressor only in cool, dust-free, dry and well-aired rooms.
 Environmental temperature should not be lower than +5
 To avoid breakdowns of the compressor the bias of the supporting surface in transversal and longitudinal
dimensions should not be more than 15 degrees.
 Make certain of observing the minimal distance between the compressor and any possible obstacle
against airflow to be 50 cm.
 Before start check, if the voltage and frequency of a power supply correspond to the data on a
identification plate of the compressor.
 Stand the compressor carefully so that the handrail to be in the working position.
MIND OUT!
Work from a power supply without foregoing conditions can lead to breakdown of the compressor.
 Connect the compressor only to a corresponding power supply.
MIND OUT!
 Pay attention instructions of possible dangers in the chapter of "Safety" beginning from page 6.

Control Elements:

Connect the compressor to a power supply.

An extension lead must have the cross section of from 2.5 mm
 Switch on the compressor by the start button (1) and the device will begin to work.
 Let the compressor work passively until the pressure reaches the ultimate value.
Preparation of the Compressor for Work
0
С and higher than +40
№ Explanation
1 Start button
2 Stop button
3 Counter of working hours
4 Protection of the electric motor (reset)
5 Manometer for measuring filling pressure
6 Filling valves (takeup cartridges)
2
and be not longer than 30 m.
0
С.
13