Powering The Qlabs ® Electrometer Off - Micropoint qLabs ElectroMeter Manual Del Usuario

• enter the Setup Mode by pressing the "SET" button to change the
ElectroMeter setting, or
• enter the Memory mode by pressing the "MEM" button to review
the previous results.
Turning the qLabs
• Perform a test.
See the appropriate sections of this User's Manual for
complete information for all of these options.
7.3 Powering the qLabs
OFF
SET MEM
VER
SHUT DOWN
OK
BACK
NOTES:
• Manually turn off the qLabs
the batteries.
• If the qLabs
off automatically and enter standby mode.
V2.4.6.12
MICROPOINT
023000E0900009
ElectroMeter ON in CHOICE 2, allows the user to:
®
ElectroMeter Off
®
In the interface where the monitor prompts
you to insert a test strip, press the functional
"OFF" button to enter the shut down mode.
In shut down mode, the user can:
• Press the functional "OK" button to
• press functional "BACK" button to
®
ElectroMeter is left idle for about 5 minutes, it will turn
®
S/N
turn off and enter standby mode, or
return to the previous interface.
ElectroMeter if not in use to conserve
10
EN EN EN