Publicidad
Idiomas disponibles
Idiomas disponibles
If passive arming is selected on, the LED will start flashing rapidly, indicating that the system is
re-arming automatically. Open any door to suspend the automatic arming. If the siren chirps 4
times and the parking lights flashed three times, then the alarm was triggered in your
absence.
If the siren did not sound when disarming, then the chirps have been turned off and you
should refer to the section titled "ELIMINATING THE ARM / DISARM CHIRPS" in this manual.
Doors Unlock - Optional
NOTE: If the optional Interior illumination feature has been added as an added convenience, the
system will turn on the interior lights when the system is disarmed.
WHILE THE SYSTEM IS SOUNDING
If during a triggered state, you wish to shut off the siren without disarming your security system,
simply press and release any transmitter button other than the Unlock/Disarm button. This action
will turn off the siren yet leave the vehicle fully armed and protected. This feature is particularly
useful if you are aware of children playing near your vehicle that may accidently trigger your security
system. In this case you can cancel the siren sounding without disarming your alarm.
INTRUSION WARNING SIGNALS
This system will inform you if an intrusion attempt has occurred while you were away from the
vehicle. If an intrusion attempt has occurred, the siren will chirp 4 times and the parking lights
will flash 3 times when disarming the system. Enter the vehicle and observe the red LED to
identify which zone was triggered.
If the LED is flashing one time...pause...one time...pause...etc., then an intrusion attempt
was made to the shock sensor, or an accessory triggering device that may have been added
to the system.
If the LED is flashing two times...pause...two times...pause...etc., then an intrusion
attempt was made to a hood or trunk pin switch that was added to the system.
If the LED is flashing three times...pause...three times...pause...etc., then an intrusion
attempt was made through one of the vehicle's doors.
These intrusion warning indicators are stored in the system's memory and will only be erased
when the ignition key is turned on.
VALET SWITCH
The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to
hand your transmitter to parking attendants or garage mechanics. When the system is in valet
mode, all alarm functions are bypassed, however the remote panic feature and remote door
locks will remain operational. In addition, the parking lights will flash to indicate locking and
unlocking. To use the valet mode, the system must first be disarmed either by using your
keychain transmitter or by use of the the manual override switch.
1. Enter the vehicle and turn the ignition key to the on position.
2. Press and hold the valet pushbutton switch until the LED turns on solid.
3. To return to normal operation, press and release the pushbutton switch any time the
ignition is on.
NOTE: Always remember to return the system to normal operation. This will ensure that the
vehicle remains protected at all times.
Page 2
128-9103
2 of 26
Publicidad
