Publicidad
Idiomas disponibles
Idiomas disponibles
DELETING TRANSMITTERS FROM YOUR SYSTEM:
It may be necessary to delete a lost transmitter or to reprioritize a transmitter that is pro-
grammed to your system. To remove a transmitter that has been programmed in your
system:
1) Enter the transmitter program mode of channel 1 as indicated above.
2) Press and hold any transmitter button that has not been programmed into channel 1 until
you hear a chirp, then release and immediately press the same button a second time until
you hear a long chirp followed by a short chirp. This action erases the transmitter.
If the transmitter you wish to erase has been lost or stolen then following the information
below will successfully remove the transmitter.
NOTE: For this procedure, you must have all transmitters you wish to remain programmed in
your system available.
1) Enter the transmitter program mode of channel 1 as indicated above.
2) Press and hold the lock button of each transmitter you wish to operate the lock function of
your unit making sure you occupy all 4 transmitter slots. In other words, you have three
transmitters you wish to remain programmed. Press and hold the lock button of transmitter
one until a long chirp is heard, then press and hold the lock button of transmitter two, then
press and hold the lock button of transmitter three, followed by pressing and holding the lock
button of transmitter one again. This action fills all 4 receiver slots.
3) Advance to receiver channel 2 by pressing the pushbutton switch one time.
4) Press and hold the unlock button of each transmitter you wish to operate the unlock
function of your vehicle, again making sure all 4 transmitter slots are filled.
4) Advance to receiver channel 3 by pressing the pushbutton switch one time.
5) Press and hold the unlock button of each transmitter you wish to operate the start function
of your vehicle, again making sure all 4 transmitter slots are filled.
If you are uncomfortable about the programming of additional transmitters as outlined in the
processes above please contact your installation center or call the technical service number
listed on the back of the transmitter for help.
BATTERY REPLACEMENT
PA91 Uses 2 x CR2016 Lithium Battery
The transmitter incorporates a small LED visible through the case
which is used to indicate battery condition. You will notice a de-
crease in transmitter range as the battery condition deteriorates.
Transmitter battery replacement is recommended at least every 10 to
12 months, depending upon how frequently the transmitter is used.
To replace the battery in the PR91 Transmitter
1) Carefully Separate apart the case using the edge of a coin as
shown.
2) Remove the rear cover to access the discharged battery
paying attention to the proper polarity orientation.
3) Carefully remove and properly dispose of the discharged battery.
4) Insert the new battery, than carefully snap closed the transmitter
case.
5) If you accidently dislodge the circuit board from the transmitter
housing, be certain that the rubber membrane is seated properly,
and the buttons are properly exposed from the front view of the
case, then insert the circuit board, and return to step #4.
Page 9
128-9103
9 of 26
Publicidad
