Publicidad
Idiomas disponibles
Idiomas disponibles
how long the vehicle will continue to run, 3, 5, or 10 minutes after the ignition switch is
turned off.
To activate the turbo timer:
Anytime the engine is running for more than 15 seconds:
1) Place the gear selector in park.
2) Set the parking, (hand), brake.
3) Be certain your foot is off the brake pedal.
4) Press the program/Push-Button switch 2 times within 5 seconds of step1.
The parking lights will flash two times indicating the mode was successfully entered.
If your parking lights flashed four times, this indicates the turbo mode was on and is now
turned off.
With the turbo timer mode selected on, after you've arrived at your destination, while the
engine is still running, set the parking brake, pause 2 seconds, then turn the ignition
switch to the off position. The engine will continue to run the allotted time according to the
selection during installation.
If you do not want the vehicle to continue to run for one cycle, simply step on the vehicle's
brake, or release the parking brake, or activate the transmitter's start button two times in
succession. Any of these will cause the engine to turn off.
PROGRAMMING TRANSMITTERS:
At times it may become necessary to program replacement or additional transmitters
for use with your system. To do this:
1) With the system unlocked or disarmed, turn the ignition key to the on position.
2) Press and release the pushbutton switch three times
The unit will flash the parking lights and or beep the horn once to indicate that the
system is in the transmitter program mode. The LED will also flash one time pause,
one time pause, etc... indicating that you are in the transmitter program mode of the
unit's channel 1 or single button program mode.
3) Press and hold the lock button of each additional transmitter you wish to operate
your system.
NOTE: The unit is capable of storing up to 4 transmitters. If a fifth transmitter is added,
the first transmitter programmed will be bumped out.
Once all transmitter have been programmed, turn the ignition switch off to exit the
program mode.
By completing the above, all three buttons of the transmitters are programmed into their
default location.
Lock
=
Lock / Arm, & Panic
Unlock =
Unlock / Disarm & Panic
Trunk
=
Trunk Release & Panic Cancel, Press & Hold 2.5 seconds to release
trunk, Press while Panic Sounding to
cancel panic immediately.
Second Vehicle Operation:
Press the Trunk/Key button + the Option button for 2 seconds, the LED flashes 2 times.
Release the buttons, then press any transmitter to select 2nd vehicle mode.
While in the 2nd car mode, press the Trunk/Key button + Option button for 2 seconds,
the LED flashes 1 time to indicate the primary vehicle operation.
Page 8
128-9103
8 of 26
Publicidad
