Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Setting the stage of the shock sensor will be effective for one arming cycle only. Once
the system has been disarmed, the very next arming cycle will cause the sensor to
default to the normal operation stage.
To change or adjust the shock sensor, press and release the ARM button of you keychain
transmitter.
1. Within 2 seconds of arming, press and release the ARM button 1 time, to
defeat the pre-detect stage of the shock sensor. (The lights will flash and the
siren will chirp twice.)
2. Within 2 seconds of step 1, press and release the ARM button 2 times, to
defeat the pre and full detect stages of the shock sensor. (The lights will
flash and the siren will chirp three times.)
3. Within 2 seconds of step 1, press and release the ARM button 3 times to
enter the "City Mode" of operation. (The lights will flash and the siren will chirp four times.)
While under control of the remote starter, the system can be programmed to allow you to inhibit
the shock sensor by use of the transmitter. If the system has been programmed during
installation, simply press the lock button of your keychain transmitter anytime during the remote
start cycle. The shock sensor will be inhibited, for one run cycle and will resume normal
operation after the remote start unit shuts off.
Check with your installation center to determine if this feature has been programmed into your
system.
OPTIONAL DEVICE OUTPUT ( CHANNEL 3 )
Controlled By: Trunk/Key Button
Other Transmitter button configurations are also available. Consult your installation center for
other configurations not listed above that may have been programmed to operate a specific
feature of your system.
This security system is equipped with an output which will activate when the appropriate
transmitter button is depressed for 3 seconds. Although this output is intended to activate the
trunk release option, any other optional devices may be connected to this channel. Consult
your installation center for more information about this output.
ADDITIONAL REMOTE FUNCTION ( CHANNEL 4 )
Controlled By: Option Button
Other Transmitter button configurations are also available. Consult your installation center for
other configurations not listed above that may have been programmed to operate a specific
feature of your system.
This security system has an additional feature that can be connected to a number of different
optional accessories. Some of the more common uses for this channel are;
a) Remote Window Closure, b) Remote Garage Door Interface, To remotely operate
the device indicated, momentarily press, or press and hold the appropriate transmit-
ter button(s) as indicated above.
TURBO TIMER MODE
This system provides a means to cool down the vehicles turbo charger, if so equipped, by
allowing the vehicle to continue to run for a prescribed period of time every time the vehicle's
engine is turned off. This feature requires the system to be set up for turbo timer during
installation. Consult with your installation center to be certain this feature was activated and
Page 7
128-9103
7 of 26
Publicidad
