Taurus 948900 Manual De Instrucciones página 4

2.3. Use and care:
2.3. Use and care:
2.3.1. Fully unroll the appliance's power cable before
each use.
2.3.2. Do not use the appliance if the parts or acces-
sories are not properly fitted.
2.3.3. Do not use the appliance when full.
2.3.4. Do not turn the appliance over while it is in
use or connected to the mains power supply.
2.3.5. Do not block the inlet or outlet ports.
2.3.6. Unplug the appliance from the mains power
supply when not in use and before undertaking any
cleaning task.
2.3.7. This appliance should be stored out of reach
of children.
2.3.8. Do not store the appliance if it is still hot.
2.3.9. Never leave the appliance unattended when in
use and keep out of the reach of children.
2.3.10. Do not vacuum any sharp-edged, hot or
incandescent material
2.3.11. The appliance should not be exposed to heat.
2.3.12. Unplug the appliance from the mains supply
socket after use and before every cleaning. Pull the
plug, not the mains cable, in order to disconnect the
appliance from the mains.
2.3.13. Ensure that blockages are removed.
2.3.14. Do not use the vacuum cleaner without dust
container or dust filter in place.
2.3.15. Do not vacuum any flour, cement etc, in
order to avoid the overloads.
2.3.16. If, for some reason, the appliance were to
catch fire, disconnect the appliance from the mains
power supply and DO NOT USE WATER TO PUT THE
FIRE OUT.
2.4. Service:
2.4.1. Make sure that the appliance is serviced only
by suitably qualified technician, and that only original
spare parts or accessories are used to replace exist-
ing parts/accessories.
2.4.2. If the power cord is damaged, the manu-
facturer or its service agent or a similarly qualified
person must
replace it in order to avoid a hazard.
2.4.3. Any misuse or failure to follow the instruc-
tions for use renders the guarantee and the manufac-
turer's liability null and void.
3. Instructions for use
3.1. Before use:
3.1.1. Remove the appliance's protective film (if
applicable).
3.1.2. Before you start the appliance, make sure
that the dust filters and dust bin is in place before
vacuuming.
3.1.3. Before you start the appliance, make sure that
the required accessory is in the position.
3.1.4. Ensure that the vacuum is fully charged before
use.
3.1.5. If the vacuum has no power, allow to charge
fully before use.
3.2. Use and care:
3.2.1. Vacuuming materials:
3.2.1.1. Ensure the washable filter is clean and dry
and installed on top of the dust bin assembly.
3.2.1.2. Ensure that the dust bin assembly is clicked
in its place.
3.2.1.3. Ensure that there are no blockages.
3.2.1.4. Ensure that the hose connections are
securely connected.
3.2.1.5. Turn on the vacuum and start vacuuming.
3.2.1.6. When you have finished vacuuming, turn the
vacuum off.
3.3. Blockages:
3.3.1. In case of any blockages check the following
in this order:
3.3.1.1. Check the floor tool for any blockages.
3.3.1.2. Check the floor tool hose connector pipe.
3.3.1.3 Check the hose handle pipe.
3.3.1.4 Remove the dust bin and check the dust bin
inlet.
3.3.1.5 If there is still a blockage after following
these steps please contact the manufacturer or its
service agent or a similarly qualified person
3.4. Operating the vacuum:
3.4.1. Charging:
3.4.1.1. Plug the charging pin into the bottom of the
charging stand.