Taurus 948900 Manual De Instrucciones página 5

3.4.1.2. Press the battery release clip then remove
the battery pack from the vacuum.
3.4.1.3. Place the battery pack into the centre slot of
the charging stand. The indicator light will start blink-
ing red, this illustrates that the battery is charging.
When the indicator light turns green it illustrates that
the battery is fully charged. It normally takes about 5
hours to fully charge the battery.
3.4.2. Connecting the accessories:
3.4.2.1. To connect the aluminium tube, line the
2 exposed pins on the tube to the 2 holes on the
vacuum. Push to lock in place.
3.4.2.2. To connect the power brush, line the 2
exposed pins on the power brush to the 2 holes on
the aluminium tube. Push to lock in place.
3.4.2.3. To connect the UV light accessory, line the 2
exposed pins on the UV brush to the 2 holes on the
vacuum. Push to lock in place.
IMPORTANT: You cannot use the UV brush with the
Aluminium tube. This is only to be used directly on
the vacuum.
3.4.2.4. The 3 in 1 accessory tool can be used
directly on the vacuum or on the aluminium tube.
The 3 in 1 accessory tool has 3 functions namely
crevice tool, dusting brush and lint remover. Press
the brush head button (12) to remove the brush
head for flat suction. The brush head can be flipped
around depending on the task at hand
3.4.3. LED lights:
3.4.3.1. 3 green LED lights indicate the vacuum is
fully charged. As the battery depletes the LED lights
will go out one by one.
3.4.3.2. If the power brush roller is blocked a
red LED will flash indicating that the roller has an
obstruction. Switch off the vacuum and clear the
obstruction. The red light should be off when you
switch the vacuum on again.
3.4.4. Cleaning the dust cup:
3.4.4.1. After each use please empty the dust cup.
Pull the dust cup out of the vacuum.