Maintenance And Care; Switching The Appliance Off; Cleaning The Appliance; Cleaning The Oven Door - Hotpoint Ariston MB 91.3/HA Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 32

Maintenance and care

Switching the appliance off

Disconnect your appliance from the electricity supply
before carrying out any work on it.

Cleaning the appliance

• The stainless-steel or enamel-coated external parts
as well as the rubber seals may be cleaned using a
sponge that has been soaked in lukewarm water and
neutral soap. If these stains are difficult to remove,
use only specialised products. After cleaning, rinse
and dry thoroughly. Do not use abrasive powders or
corrosive substances.
• Ideally, the inside of the oven should be cleaned after
each use, when it is still lukewarm. Use hot water
and detergent, rinse and dry with a soft cloth. Do not
use abrasive products.
• All accessories - with the exception of the sliding
racks - can be washed like everyday crockery, and
are even dishwasher safe.
• Never use steam cleaners or pressure cleaners on
the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a sponge
and a non-abrasive cleaning product, then dry
thoroughly with a soft cloth. Do not use rough abrasive
material or sharp metal scrapers as these could scratch
the surface and cause the glass to crack. To clean
more thoroughly, you can remove the oven door.
1.
Open the oven door fully (see diagram).
2.
Lift up and turn the small levers located on the
two hinges (see diagram).
3. Grip the door on the two
external sides and close it
approximately half way. Unlock
the door by pressing on the
clamps F F F F F , then pull the door
F
towards you lifting it out of its
seat (see diagram).
To replace the door, reverse this
sequence.
All manuals and user guides at all-guides.com
F
Inspecting the seals
Check the door seals around the oven periodically. If
the seals are damaged, please contact your nearest
After-sales Service Centre (see Assistance). We
recommend not using the oven until the seals have
been replaced.
Replacing the light bulb
To replace the oven light bulb:
1. Remove the glass cover of the lamp-holder.
2. Remove the light bulb and replace it with a similar
one: Wattage 25 W, cap E 14.
3. Replace the glass cover (see diagram).
GB
21

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Mb 91.3 ix/ha

Tabla de contenido