Descargar Imprimir esta página

KTM Power Parts 76512020000 Manual De Instrucciones página 6

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

6
A
A
1
Scope of delivery:
Luggage carrier system
1x carrier left
1x carrier right
1x connecting bar
2x washers 24x8.5x3
2x washers 16x8.5x1.5
4x flat-head screw M8x70
2x hex screw M8x16
2x oval head screw M8x20
2x nuts M8 self-locking
2x hex screw M8x16
Preparations
Remove the rear and drill out the markings to ø15mm.
Replace the rear.
Assembly
Right side
Fit the carrier as shown in the picture. Fit the flat-head screws M8x70 at
position (A).
Do not tighten yet.
Left side
Assembly as for the right side.
NOTE:
The carrier system can be fitted with or without the passenger footrests.
Fitting without passenger footrests
Place the 24x8.5x3 washer between the carrier and the footrest bracket and
fix the carrier with M8x16 hex screws + 16x8.5x1.5 washers (Loctite 243).
Tighten the M8x70 flat-head screws (20Nm).
NOTE:
Fitting is the same left and right.
Fitting with passenger footrests
Start as with fitting without passenger footrests.
Insert the 20x8,5x8 bushing (1) between the passenger footrests and the
footrest bracket at the lower drill hole and fix it with the M8x25 allen head
screws (25Nm).
NOTE:
Fitting is the same left and right.
Passenger footrest
2x bushing 20x8.5x8
4x allen head screw M8x25

Publicidad

loading