KTM Power Parts 76512020000 Manual De Instrucciones página 7

Fit the connecting bar on the left and right with M8x20 oval head screws
and M8 nuts.
Do not tighten yet.
Align the bar.
Screw the number-plate bracket (1) (not supplied) or number plate direct to
2
the rear section (2) and connecting bar (3). The M6x40 (4) hex screws are
part of the scope of delivery. Fit the remaining connecting material (washers
and nuts) of the number-plate bracket.
4
3
1
7
Tighten the screws on the left and right.
Fitting the case
NOTE:
Luggage cases are of different capacities!
To achieve the same motorcycle width on the left and right, the 35l case
must be fixed on the exhaust side, and the 41l case opposite the exhaust
side.
Fit the bottom of the case to the carrier.
Fit the hanger to the carrier.
Turn the hanger in the direction of the arrow as far as the groove in position
(A).
A