Tabla de contenido
Publicidad
installation guide
Always use two people when setting up the base.
STEP 1
Place the bed base box in a desired location with the bottom of the
box facing up.
Remove the binding straps and packing materials, making sure not
to puncture the box with any sharp objects.
STEP 2
Remove the bed base from the box keeping the bottom of the
base facing upwards.
STEP 3
To install headboard brackets (sold separately)
see instructions on page 11.
To install the legs, thread the washer over the bolt of the leg with
the recessed side facing the leg, and tighten by hand.
Do not over tighten.
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
6
All manuals and user guides at all-guides.com
STEP 4
To install the legs, thread the washer over the bolt of the leg
with the recessed side facing the leg, and tighten by hand.
Do not over tighten.
Locate the Backup Battery Pack and install
(4) 9 Volt batteries (not included).
Store the battery pack in a convenient
location for emergency use. For operating
instructions see page 8.
STEP 5
Uncoil input cord (connected to control box's
power port) and plug into Power Supply.
STEP 6
Uncoil the Power Cord and connect to the
Power Supply. Place Power Supply on the
ground and extend from the base. Ensure
that the Power Supply and all attached
cords are directed toward the desired surge
protector.
installation guide
STEP 7
Carefully flip the base over on to its legs. Important: Two people are
required to move the bed base. Do not drag across the floor. Do not
rest frame on its side, excessive pressure may damage the legs.
STEP 8
Plug the power cord into a power source.
A surge protector is recommended.
STEP 9
Quickly test remote functions to verify proper setup before placing
mattress on base. Return the base to a flat position before placing
the mattress on top.
For customer support, visit www.ergomotion.com or call: 1-888-550-3746
STEP 10
Slide the left side of the mattress retainer bar into the bracket.
Pull the retainer bar to the opposite bracket and secure the right
side.
Setup is now complete! Test all functions on remote.
7
Publicidad
Tabla de contenido
