Emergency Battery Backup Pack; Connecting Strap - Ergomotion 40+ Serie Guia De Inicio Rapido

emergency battery backup pack

Store the battery pack in a convenient location for emergency use.
(4) 9 Volt batteries are required to operate the power down feature and are NOT included.
OVERVIEW
For emergency use only, in case of a power outage.
In the event that the base is stuck in an articulated position during a power outage- the Battery
Backup Pack will return the base to a flat position. Batteries are not to be used for normal operation
of the base.
Remove the battery pack after the emergency is over, as the system will continue to draw power from
the batteries, even if not in use.
STEP 1
Install the 9 volt batteries into the provided battery pack.
Do not mix brand name batteries.
8
All manuals and user guides at all-guides.com
STEP 2
Connect battery pack to input power cord attached to control box.
Battery
Backup Box
Input
Power Cord
Control Box
If the base is in the upright position use the remote to return to a
flat position.
connecting strap (optional)
If any split setup is being installed, plastic connecting straps are provided (one per base) to secure the bases to-
gether. Use both straps to secure the head and foot portions together.
STEP 1
With the bases in their desired location, slightly loosen both legs to
allow the strap to fit on the leg bolt, between the leg washer and
frame.
STEP 2
Slide side (a) of the connecting strap onto leg bolt. Swing the
strap and connect side (b) to the leg bolt. Secure the strap by
shifting to the left.
a b
STEP 3
Re-tighten legs. Do not over tighten. Use the remaining strap and
repeat on other end of the base.
9