Publicidad
Idiomas disponibles
Idiomas disponibles
Soaking regulator parts in warm water will remove more salt and mineral deposits
than will conventional rinsing. It will loosen deposits on interior components that
rinsing will not (If no charged air cylinder is available, follow the above procedure but
be very careful NOT to depress the purge button, or leave dust cap off, when the
regulator is submerged in water. Failure to do this will allow water to enter both
regulator stages and may result in internal corrosion).
Simply soak the entire exterior of the first stage thoroughly, and proceed as above
when cleaning the second stage.
3.
Store in a clean equipment box, or as an alternative, seal inside a plastic bag. Store
in a clean dry place.
4.
Lightly lubricate the yoke screw with silicone grease.
5.
Never store the regulator while it is still connected to the diving cylinder.
6.
Do not use any type of solvent to clean any part of the regulator. Do not expose any
part of the regulator to silicone spray, as some aerosol propellants attack or degrade
rubber and plastic material.
7.
Do not carry the diving cylinder by the regulator as such abuse will eventually
damage the regulator or the cylinder valve. Do not expose the regulator to
unnecessary shocks or impact.
CONTAMINATED WATER DIVING
Sophisticated diving gear designed for use in contaminated water provides constant
positive pressure inside the regulator case and utilizes redundant exhaust valve
passages. TUSA regulators are not designed to provide this requirement and therefore
are not recommended for use in contaminated water diving.
RS-350/340/680/790 DRY USE IN
This is important information. Be sure to read it.
WARNING:
RS-350/340/680/790DRY regulators for the European market have passed the cold water
performance test (water temperature: 4°C) specified by EN250.
All manuals and user guides at all-guides.com
SECTION V
SECTION VI
COLD WATER DIVING
- 10 -
20
Regulators
Regulators
GB
GB
Publicidad
Capítulos
