Stanley FatMax FMC040 Manual De Instrucciones página 10

90577313 FMC040 12 V Impact Driver.qxd:??????-00 Cir Saw book 8/3/11 2:35 PM Page 10
QUICK RELEASE CHUCK (FIG. H)
H
WARNING:
Make certain the lock-off button
is engaged to prevent switch actuation before
3
installing or removing accessories.
NOTE: The chuck accepts 1/4 inch (6.35 mm) hex
accessories only.
Place the switch in the locked off (center) position
or remove battery pack before changing
accessories.
To install an accessory, pull the chuck collar (3)
away from the front of the tool, insert the
accessory, and release the collar. The accessory is locked in place.
To remove an accessory, pull the chuck collar (3) away from the front of the tool,
remove the accessory and release the collar.
ON BOARD BIT STORAGE
A magnetic bit storage slot (6) is built-in to the area on the top of the tool.
BELT CLIP
A belt clip (7) is provided which can be switched to either side of the tool.
This Class B digital apparatus complies with Canadian ICES-003.
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment. This Class B
digital apparatus complies with Canadian ICES-003.
THE RBRC™ SEAL
The RBRC™ (Rechargeable Battery Recycling Corporation) Seal on the
lithium-ion battery (or battery pack) indicates that the costs to recycle the
battery (or battery pack) at the end of its useful life have already been paid by
Stanley FatMax.
RBRC™ in cooperation with Stanley FatMax and other battery users, has established
programs in the United States to facilitate the collection of spent lithium-ion batteries.
Help protect our environment and conserve natural resources by returning the spent
lithium-ion battery to an authorized Stanley FatMax service center or to your local retailer
for recycling. You may also contact your local recycling center for information on where to
drop off the spent battery.
RBRC™ is a registered trademark of the Rechargeable Battery Recycling Corporation.
10