BALDR B0340WST2H2R-V8 Manual Del Usuario página 14

Problem
Inaccurate
temperature/
humidity
"HH.H/LL.L" display
in indoor and/or
outdoor temperature
If your BALDR product does not operate properly after trying the
troubleshooting steps, please contact the seller on your order
page or shoot an email to: service@baldr.com.
PLACEMENT INSTRUCTION
BALDR sensors are sensitive to surrounding environmental condi-
tions. Proper placement of both the main unit and outdoor sensor
are critical to the accuracy and performance of this product.
BACKLIGHT FUNCTION
Place main unit in a dry area free of dirt and dust. To help ensure
an accurate indoor temperature measurement, be sure to place the
Main unit away from heat sources or vents.
Outdoor Sensor Placement
Sensor must be placed outside to observe outdoor conditions.
Sensor is water resistant for water splashes and is designed for
general outdoor use, however, to extend its life place the sensor in
an area protected from direct weather elements. The best location
is 1.2 to 2.4 meters (4 to 8 feet) above the ground with permanent
shade and plenty of fresh air to circulate around the sensor.
Possible Solution
Make sure both the main unit and sensor
are placed out of direct sunlight and away
from any heat sources or vents.
If the temperature is higher than the detec-
tion range, "HH.H" will display on screen for
indication; if lower than the detection range,
"LL.L" will display on screen for indication.
14