When The Work Is Done; Changing The Filter - Bosch BSGL5 Serie Instrucciones De Uso

Vacuuming
!
Please note:
Depending on the type of hard floor involved (e.g.
rough rustic tiles), floor tools are subject to a certain
amount of wear. Therefore, you must check the
underside of the floor tool at regular intervals. Worn
undersides of floor tools may have sharp edges that
can damage sensitive hard floors, such as parquet or
linoleum. The manufacturer does not accept any
responsibility for damage caused by worn floor tools.
10
Figure
Adjusting the floor tool:
Rugs and carpets
Hard floors
11
Figure
● Remove the crevice nozzle or upholstery nozzle from
the accessories compartment in the appliance lid.
12*
Figure Vacuuming with accessories
Attach the nozzles to the suction pipe or handle as
required:
a)Crevice nozzle for vacuuming crevices and corners, etc.
b)Upholstery nozzle for vacuuming upholstered
furniture, curtains, etc.
c) Hard-floor tool
For vacuuming hard floor coverings
(tiles, parquet flooring, etc.)
● Push the telescopic tube into the connecting piece
of the hard floor tool until it locks in place.
● To release the connection, press the locking collar
and pull out the telescopic tube.
13*
Figure Professional upholstery nozzle
● For intensive cleaning of upholstered furniture
(attach to the handle or suction pipe, depending on
requirements).
● To clean the professional upholstery nozzle, simply
vacuum it using the handle.
14
Figure
● After use, place the crevice or upholstery nozzle back
into the accessories compartment in the appliance
lid.
Turbo brush
If your appliance is equipped with a turbo brush,
consult the accompanying instruction manual for
instructions on its use and maintenance.
15
Figure
● You can use the parking aid on the back of the
appliance if you wish to stop vacuuming for a short
time.
● Once you have switched off the appliance, slide the
hook on the floor tool into the recess on the rear of
the appliance.
Figure
To overcome obstacles, e.g. steps, the appliance can
also be carried by the handle on the appliance body.

When the work is done

Figure
● Pull out the mains plug.
● Tug the power cord briefly and then let go
(the power cord retracts automatically).
Figure
● To store or transport the appliance, you can use the
storage aid on the underside of the appliance.
=>
● Stand the appliance up on its end. Slide the catch on
the floor tool into the groove on the underside of the
=>
appliance.
Changing the filter
!
Please note: Always switch off the appliance before
changing the filter.
Replacing the bag
19*
Figure
● If the dust bag change indicator lights up red
continuously when the floor tool is lifted from the
floor and the highest power setting has been
selected, the dust bag must be changed, even
though it may not yet be full. Even if the dust bag is
not full, it may still need changing, due to the type of
dust which has been vacuumed.
First check that the nozzle, suction pipe and flexible
hose are not blocked, as this would also lead to the
dust bag change indicator being triggered.
Figure
● Open the lid by moving the locking lever in the
direction of the arrow.
Figure
a) Seal the dust bag by pulling the sealing plate, and
remove the bag.
b)Slide the new dust bag into the holder up to the stop.
!
Please note: the lid will only close if a dust bag has
been inserted.
* Dependent on model
16
17
18
20
Opening the lid
21
39