ROTOR 2 IN PUWER Manual De Usuario página 38

2.6. FINE TUNE ADJUSTMENT
2.6.1. If the crank does not turn smoothly even with the left-side bolt not tightened, remove the
0.5 mm washer from the left side and repeat the installation.
2.6.2. If you see that there is lateral play even with the left-side bolt completely tightened, use an
additional 0.5 mm plastic washer on the left side and repeat the installation steps.
2.7. UNINSTALLING 2INpower CRANKS.
2 .7.1. Counterclockwise turn the DTT bolt (1) in the left-side crank using a 5 mm allen wrench.
Afterwards, unscrew the left-side bolt (2) using a 5 mm allen wrench until it is removed. Take
the left-crank out of the axle.
Do not remove the DTT bolt. If it is removed it will break and this will void the warranty.
38 Cranks installation
(1)
(2)