ROTOR 2 IN PUWER Manual De Usuario página 50

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Can I disassemble the elements of my power
meter?
No. Inadequate handling of the product will
invalidate the warranty.
The only parts that can be disassembled are those
that are involved in installing and uninstalling
the cranks on the bicycle. Read the user manual
carefully before handling the product.
Never try to disassemble the plastic pieces on the
sides of the right crank arm or the electronics inside
the axle.
Do not try to disassemble either the mechanical
elements assembled by the manufacturer, such
as the axle with the right crank, or the DTT bolt
and insert in the left crank.
How to charge the battery?
Read the user manual for proper battery charging.
Open the dust cover in the drive-side crank and
connect the magnetic connector from the USB cable
included in the box. Make sure that the LED in the
right crank blinks yellow or green. The LED light will
turn off when charging is complete.
Can I replace the battery?
ROTOR 2INpower uses a Lithium (Li-ion) battery the
same size as a standard AA battery. It has 3.7 V
nominal tension and 800 mAh capacity. It can
complete 300 charges without damage, and a
complete charge lasts for 250 hours of use. This
means that one single battery should last for 75000
hours without damage, enough time not to require
replacement during the complete lifetime of the
power meter. In case battery replacement is needed
you should contact your ROTOR dealer and they will
assist you.
50
Frequently asked questions
If I usually connect my 2INpower to the User Software
running on the computer, is the battery life still
250 hours?
If fast mode is active (only possible with User Software),
battery consumption is higher due to the higher
frequency of data emission required by the TORQUE 360
graph. Always disconnect the power meter when closing
the program to make sure that fast mode is off.
How can I clean my 2INpower cranks? Are they
waterproof?
2INpower is waterproof. It has successfully passed IPX7
level.
However, it is not recommended to clean your power
meter with high pressure and avoid direct water impact
on the seals. Do not use solvents or degreasers; they can
damage some power meter elements.
How can I update the firmware for my cranks? How
often do I have to update the firmware?
ROTOR sometimes offers firmware updates with
improvements.
The update process is wireless; to complete this you will
need to download the User Software from the ROTOR
website.
To connect the crank to the computer, the USB ANT+
dongle is needed.
You can also connect the 2INpower to the User Software
TM
via Bluetooth Smart.
What happens if there is an error while updating the
firmware?
If any error occurs during the updating process, you need
to try the update again until it successfully finishes. If the
update process begins and the program detects any
problem, the process will restart a maximum of 5 times
before cancelling the update.
If the firmware update is done via ANT+ , it is recommended
TM
to place the ANT+ dongle as close to the cranks as
possible for better radio signal reception.
TM
TM

Hide quick links:

Publicidad

Capítulos

Tabla de contenido
loading

Productos relacionados para ROTOR 2 IN PUWER

Este manual también es adecuado para:

2inpowerRot115

Tabla de contenido