Water Supply; Connect Water Supply; Connect High-Pressure Hose To Spray Gun; Spray Gun - Generac 0068090 Manual Del Usuario

2. Place unit on level ground in a well venti-
lated area.
3. Clean area around fuel cap and remove
cap slowly.
4. Slowly add recommended fuel. Do not
overfill.
Figure 2-10. Add Recommended Fuel
5. Install fuel cap.
NOTE: Allow spilled fuel to evaporate
before starting unit.

Water Supply

NOTE: DO NOT run unit without sufficient
water supply. Failure to follow water sup-
ply requirements will void unit warranty.
Water supply must meet the following require-
ments:
• DO NOT siphon standing water for the
water supply.
• Water temperature must be less than 100
°F (38 ºC).
• Water supply hose length must not exceed
50 ft (15.2 m).
• Water must be greater than 3.8 gallons per
minute (17.3 liters per minute) and no less
than 30 psi (206.8 kPa).
• DO NOT use a one-way valve, vacuum
breaker, or check valve in any part of the
water supply.

Connect Water Supply

1. Remove and discard shipping cap from
the pump water inlet.
2. Run water supply for 30 seconds prior to
connection to eliminate debris.
3. See Figure 2-11. Inspect inlet screen for
debris. Clean screen or replace as neces-
sary. DO NOT run power washer if inlet
screen is damaged or missing.
6
Figure 2-11. Inspect Inlet Screen
4. See Figure 2-12. Connect water supply
hose to pump water inlet and hand-
tighten.
Figure 2-12. Connect Water Supply Hose
000117
Connect High-Pressure Hose to

Spray Gun

1. See Figure 2-13. Connect lance to spray
gun and hand-tighten.
Figure 2-13. Connect Lance
2. See Figure 2-14. Connect high-pressure
hose to pump and hand-tighten.
Figure 2-14.Connect High-Pressure Hose to
000118
Pump
Operator's Manual for Power Washer
000119
000120
000121