Inspect Engine Spark; Inspect Muffler And Spark Arrester; Inspect Spark Arrester Screen; Storage - Generac 0068090 Manual Del Usuario

A
Figure 3-13. Spark Plug
NOTE: Replace spark plug if electrodes are
pitted, burned or porcelain is cracked. Use
ONLY recommended replacement plug.
See Specifications.
4. Install spark plug finger tight, and tighten
an additional
3/8 to 1/2 turn using spark plug wrench
(B).

Inspect Engine Spark

Accidental Start-up. Disconnect spark plug wire when
working on unit. Failure to do so could result in death
or serious injury.
1. Disconnect spark plug wire from spark
plug.
2. Secure spark plug wire where it cannot
contact spark plug.
3. Test spark plug with approved spark plug
tester.
NOTE: DO NOT inspect for spark with
spark plug removed.

Inspect Muffler And Spark Arrester

NOTE: It is a violation of California Public
Resource Code, Section 4442, to use or
operate the engine on any forest-covered,
brush-covered, or
unless the exhaust system is equipped
with a spark arrester, as defined in Section
4442, maintained in effective working
order. Other states or federal jurisdictions
may have similar laws.
Contact original equipment manufacturer,
retailer, or dealer to obtain a spark arrester
designed for exhaust system installed on this
engine.
NOTE: Use ONLY original equipment
replacement parts.
Inspect muffler for cracks, corrosion, or other
damage. Remove spark arrester, if equipped,
inspect for damage or carbon blockage.
Replace parts as required.
Operator's Manual for Power Washer
B
WARNING
grass-covered

Inspect Spark Arrester Screen

1. Loosen fasteners and remove heat shield
from muffler.
2. Loosen fasteners and remove spark
arrester from muffler.
3. Inspect spark arrester. Replace if torn, per-
forated or otherwise damaged (part num-
ber 0K1851).
4. If screen is not damaged, clean it with a
commercial solvent and replace.
(000102)
Figure 3-15. Spark Arrestor Fasteners

Storage

land

General

• DO NOT store fuel from one season to
another unless properly treated.
WARNING
Hot Surfaces. When operting machine, do not
touch hot surfaces. Keep machine away from
combustables during use. Hot surfaces
could result in severe burns or fire.
Figure 3-14. Heat Shield Fasteners
DANGER
Explosion and Fire. Fuel and vapors are extremely
flammable and explosive. Add fuel in a well
ventilated area. Keep fire and spark away. Failure to
do so will result in death or serious injury.
WARNING
Risk of Fire. Verify machine has properly cooled
before installing cover and storing machine.
Hot surfaces could result in fire.
(000108)
000135
000136
(000105)
(000109)
13