Initial Inspection 4.1 General; Initial Inspection - Jacobsen InCommand PGM 22 Manual Tecnico

4

INITIAL INSPECTION

4.1 GENERAL________________________________________________________________
The set-up and testing of the unit should always be
performed by a trained technician, familiar with the
operation of the equipment.
Read each instruction completely and make sure you
understand it before proceeding with the assembly. Stay
alert for potential hazards and obey all safety
precautions.
The RIGHT, LEFT, FRONT, and REAR of the machine
are referenced from the operator's position, facing
forward.
4.2 INITIAL INSPECTION_______________________________________________________
The initial inspection should be performed only when the engine is off and all fluids are cold. Disengage all drives,
engage parking brake, stop engine, and disconnect spark plug wire.
1. Perform a visual inspection of the entire unit, look for
signs of wear, loose hardware, and components that
may have been damaged during transport.
2. Inspect paint and decals for damage or scratches.
Decals provide important operating and safety
information. Replace all missing or hard to read
decals.
3. Check that the engine oil level is at the full level
mark with the engine cold.
NOTICE
Mower is shipped without oil in the engine. To prevent
permanent damage, oil must be added before starting
engine. See Section 8.3 for oil specifications
4. Visually check for fuel or oil leaks.
5. Inspect lube points for proper lubrication.
All manuals and user guides at all-guides.com
Accessories not included with this product must be
ordered separately. See instructions provided with
accessory for installation and parts.
Do not attempt to operate the machine unless you are
familiar with this type of equipment and know how to
operate all controls correctly.
This machine is shipped assembled. After unpacking,
perform the initial inspection, operating checks, and test
the Operator Presence Control (OPC).
!
CAUTION
INITIAL INSPECTION
!
CAUTION
4
en-13