Extending The Cutting Lines; Cleaning And Maintenance; Cleaning; Exchanging The Line Spool - Grizzly Tools ERT 3525 Traducción Del Manual De Instrucciones Original

Cut the grass by
swaying the trim-
mer sideways to
the right and left.
Cut slowly, keeping
the appliance in-
clined forward
slightly when cut-
ting.Cut tall grass by a series of levels
from top to bottom.

Extending the cutting lines

The equipment comes with a tap mecha-
nism, i.e. the thread extends if the cut-
ting head is tapped on the ground. If the
thread is initially longer than the cutting
radius allows, it will be automatically
shortened to the correct length by the
thread cutter.
Caution: Regularly remove grass rem-
nants from the thread cutter so the cutting
effect is not impaired.
Regularly check the nylon lines for
damage and whether the lines still
have the correct length defined by
the line cutter.
In Case of Deteriorating Cutting Perfor-
mance:
• Switch on the equipment and hold it
over a lawn area.
• Tap the cutting head (
ground. The cutting head is adjusted
if the ends of the thread are at least
2.5 cm long.
If the Ends of the Thread are Shorter
than 2.5 cm:
• Switch off the equipment and discon-
nect it from the mains.
• Press the reel insert until it stops and
give a strong pull on the thread end.
If No Thread Ends are Visible:
•

Cleaning and maintenance

Cleaning

Always keep the trimmer clean.
•
9) on the •
•

Exchanging the line spool

Replace the thread reel (see chapter
on "Changing the Thread Reel").
Always disconnect the plug from
the mains socket before working
on the trimmer.
Any work that is not described
in these Instructions must be
carried out by a servicing agen-
cy authorized by us. Only use
original parts and be very care-
ful with the line cutter during in-
stallation work. Danger of injury!
Do not jet water onto the trimmer
and do not clean it under flow-
ing water. This would result in the
danger of an electric shock and the
trimmer could be damaged.
Do not use cleaning agents and
solvents.
After the work has been completed
remove all grass and soil from the cut-
ting device and the protective cover).
Ensure that the ventilation slots are
always clean and free of grass.
Clean the trimmer with a soft brush or
a cloth.
Never manipulate the cutting de-
vice by inserting worn out origi-
nal or alien parts. Only use origi-
nal spare parts. Never use metal
lines. The use of alien parts can
GB
21