Erreka VULCAN Manual Del Instalador página 66

INSTALLATION
Connect the operator to the switchboard
CLOSE OPEN
P1 P2 P3 P4 P5 P6 P15 P14 P16
ST1 FT1 ST2 FT2 FCA1 FCC1
1
Motor connection (common)
2
Motor connection (turning 1)
3
Motor connection (turning 2)
4
Earth
Position the end cap and tighten the gland
62
Installation manual
All manuals and user guides at all-guides.com
G1 G2 G3
P7 P8
P11 P12 P22 P23 G7 G8 G9 G10
Courtesy
LOCK 24Vac Lamp. MOTOR1 (G2-G1-COM)
STOP
Light
VIVO- M101:
230Vac/ 50Hz
VIVO- M101M:
125Vac/ 60Hz

Before making any electrical connections,
check the switchboard instructions manual.

We recommend using the VIVO-M101(M) or VIVO-
M201(M) switchboards.
1 Connect the operator to the switchboard.
2 Connect the capacitor (C) in cable connectors Turn
1 and Turn 2.
3 Connect the closing (FCC) and opening (FCA) limit
switch.
4 Connect the switchboard to the electricity supply.
N L
POWER
5 Activate the power supply switch.
 Before carrying out any gate movement,
ensure there is no person or object in the radius
N L
of action of the gate and the drive mechanisms.
6 Use the switchboard mini-pushbuttons (CLOSE-
OPEN) to check the motor connections are correct
(turning direction).
P140W

If the
interchange the cables 2 and 3.

Ensure the earth cable is properly connected.
1 Position the end cap (1) in its housing (2) and attach
using the screws (3).
2 Tighten the gland (4) to ensure the electrical cable
input (5) is seal tight.
turning direction is not correct,