Waeco MAGIC Control MTPM-100 Instrucciones De Montaje Y De Uso página 66

MTPM-100.book Seite 66 Freitag, 15. Juli 2005 4:37 16
All manuals and user guides at all-guides.com
Using MAGIC CONTROL
✓ The controller confirms the sensor with a high-pitched beep.
➤ If you do not want to program this sensor, press the display button.
✓ The controller remembers the previously installed sensor.
✓ The controller confirms the setting with a high-pitched beep.
Additional sensors
You can also program two additional sensors (available as accessories),
for example if you have two extra inner rear tyres.
➤ If you do not want to program any more sensors, wait a minute
without pressing the display button.
✓ The controller quits tyre sensor programming mode.
✓ The system is in operating mode.
➤ If you want to program more sensors press the display button for
3 seconds within a minute.
✓ The LED flashes green five times every 3 seconds to indicate the left
additional tyre.
➤ If you want to program the sensor in the left additional tyre, let down the
tyre pressure by 0.2 bar.
✓ The controller confirms the sensor with a high-pitched beep.
➤ If you do not want to program this sensor, press the display button.
✓ The controller remembers the previously installed sensor.
✓ The controller confirms the action with a high-pitched beep.
✓ The LED flashes green six times every 3 seconds to indicate the right
additional tyre.
➤ If you want to program the sensor in the right additional tyre, let down the
tyre pressure by 0.2 bar.
✓ The controller confirms the sensor with a high-pitched beep.
➤ If you do not want to program this sensor, press the display button.
66
MAGIC CONTROL