Operating Instructions; Before Starting; Starting; Stopping - Dynapac BG39 Power Float Manual De Instrucciones

1x 10mm Flat spanner.
-
1x 13mm Flat spanner.
-
- 1x 17mm Flat spanner.
1x 5mm Hexagonal spanner .
-
1x 8mm Hexagonal spanner .
-
- 1x Screw driver 3 mm width.
1x Cruciform screw driver.
-

OPERATING INSTRUCTIONS

KEEP CLEAR OF ROTATING PARTS WHEN OPERATING .
ALWAYS HAVE THROTTLE POSITION AT IDLE WHEN STARTING ENGINE .
NEVER LIFT BY THE GUARD RING .
REMOVE SMOOTHING DISC BEFORE LIFTING .
ALWAYS TEST SAFETY SWITCH FOR PROPER OPERATION BEFORE BEGINNING .
NEVER REFUEL WHILE RUNNING OR WHILE ENGINE IS HOT .
REFUEL IN WELL VENTILATED AREA, AWAY FROM SPARKS AND OPEN FLAME .
ALWAYS DISCONNECT SPARK PLUG BEFORE SERVICING .

BEFORE STARTING

ALWAYS HAVE THE THROTTLE AT IDLE WHEN STARTING ENGINE
- Check engine oil level.
- Fill gasoline tank.
- Make sure that all blades are at the same angle. If necessary adjust the blade angle.

STARTING

- Turn the fuel valve "ON".
- Set safety switch on "ON" position.
- Close choke located on the engine only if the engine is cold.
- After the engine starts open choke for smooth running and let the engine warm up for two or three minutes
at idle speed. Then, adjust the throttle at desired speed to get the blades rotating.

STOPPING

- Set throttle at idle speed.
- Set the safety switch to "OFF" position.
File: 4700369016_ENG_NO.doc
INSTRUCTION MANUAL – BVG39
CAUTION
IMPORTANT
Page 9 / 24