Installing The Cooker Hood - Luisi Air TRENTO Instrucciones De Uso Y De Montaje

INSTALLING THE
COOKER HOOD
1. Before carrying out the appliance installation,
please check that all components are not da-
maged, in such a case contact your retailer
and do not carry out any installation operation.
Before the installation of the downdraft, ple-
ase remove the safety piece you can see in
the picture (Fig. 1). Furthermore, please 'Be-
fore the installation of the Downdraft, please
remove the packaging,' Furthermore, please
read carefully all of the following installation
instructions..
● Use an air exhausting pipe whose maximum
length does not exceed 5 meters.
● Limit the number of elbows in the piping,
since each elbow reduces the air capacity of
1 linear meter. (Ex.: if you use no. 2 x 90° el-
bows, the length of piping should not exceed
3 meters).
● Avoid abrupt direction changes.
● Use a 150 mm. constant diameter pipe for
the whole length.
● Use piping approved by standards in force.
The manufacturer shall not be deemed re-
sponsible for air capacity or noise problems
caused by failure to comply with the above
instructions and no warranty on the product
shall be provided.
2. Before making the hole, check that there are
no structural or other parts inside the cabinet,
where the appliance is to be placed, which
could hinder a proper installation.
Check that the dimensions of the Downdraft
and the ones of the cook top are compatible
with the cabinet so that the installation can be
carried out properly.
3.
Make a rectangular opening, 790 x 100 mm in
size, in the back of the cook top .In the version
with the motor already installed, remove the
screws and the suctioning unit in order to fit the
down draft in the opening made.
16
All manuals and user guides at all-guides.com
EN
4.
Fit the Downdraft in the opening, by inserting it
from above as shown in (Fig. 1).
5.
Secure the downdraft inside the cabinet, by
using the special fixing brackets supplied with
the product (Fig. 2). Insert the brackets in the
lower side of the downdraft, in such a way that
there is a 3 mm gap between the lower side of
the bracket and the bottom of the cabinet (Fig.
3). This distance will allow to pull the appliance
downwards during installation, in order to make
the stainless steel frame perfectly adhere with
the worktop. Before inserting the screws into
the cabinet, please make sure that the applian-
ce is perfectly perpendicular with the worktop.
6.
After completing the installation and connec-
ting the appliance to the power supply, lift up
the downdraft by pressing on the glass, as
shown in (Fig. 4).
Remove the felt protections as shown in (Fig.
14).
Fit the charcoal filters, if the appliance is used
in the recycling mode (charcoal filters are sup-
plied in a separate kit), the grease filters (see
Fig. 10), and then fit the front glass by sticking
the magnets into the specific seats (see fig.13).
7.
If the Downdraft is equipped with external mo-
tor, place the suctioning unit (external motor)
in a suitable area and fit the exhaust air flue.
Then fit the air outlet ducts between the ex-
ternal motor and the downdraft. Select the air
outlet among the five available options (Fig. 6)
and fit the union supplied with the appliance.
8.
Place the metal box containing the electro-
nic components in an easily reachable area
for possible technical assistance operations.
(Fig.7), by connecting the related connectors
(fig. 8A ).
9.
If the Downdraft is equipped with external mo-
tor, connect the motor unit cable to the specific
terminal board found on the plastic box shown
.
in Fig. 8 B
10.
Power the cooker hood.
TRENTO